The syntax for command line use is:
StyleVision [<SPS File>] [<options>]
|StyleVision||calls StyleVision, which is located in the StyleVision application folder|
|<SPS File>||specifies the SPS file|
|<options>||One or more of the options listed below.|
When a command is executed StyleVision runs silently (i.e. without the GUI being opened), generates the required output files, and closes. If an error or warning is encountered, the GUI is opened and the corresponding message is displayed in a message box.
|Note:||For the SPS to load correctly in StyleVision, the XSD and Working XML files that the SPS uses must be at the locations specified for them in the SPS.|
Options may be entered in any order.
•XSLT file output
Writes XSLT-for-HTML to the specified file
Writes XSLT-for-RTF to the specified file
Writes XSLT-for-Text to the specified file
Writes XSLT-for-FO to the specified file
Writes XSLT-for-Word 2007+ to the specified file
•DB data output
Writes XML generated from DB to the specified file.
Writes XML Schema generated from DB to the specified file.
StyleVision "QuickStart.sps" -outxslt="QuickStartHTML.xslt"
StyleVision "C:\Test\QuickStart.sps" -outxslt="C:\Test\QuickStartHTML.xslt"
Points to note
Note the following points:
•Paths may be absolute or relative and should use backslashes.
•If the filename or the path to it contains a space, then the entire path should be enclosed in quotes. For example: "c:\My Files\MyXML.xml" or "c:\MyFiles\My XML.xml".
•Commands, paths, and folder and file names are case-insensitive.