Please enable JavaScript to view this site.

Altova MapForce 2020 Basic Edition

After you add an Input component to the mapping area, notice the default item to the left of the component.

map_simple_input

Simple input component

The default item enables you to connect an optional default value to this input component, as follows:

 

1.Add a constant component (on the Insert menu, click Constant), and then connect it to the default item of the input component.

cmd-inp6

2.Double click the input component and make sure that the Input is required check box is disabled. When you create a default input value, this setting is not meaningful and causes mapping validation warnings.

dlg_simple_input_edit

3.Click OK.

 

Note:If you click the Specify value check box and enter a value in the adjacent box, the entered value takes precedence over the default value when you preview the mapping (that is, at design-time execution). However, the same value has no effect in the generated code.

© 2019 Altova GmbH