Altova RaptorXML+XBRL Server 2024

RaptorXML+XBRL Server is available for installation on Linux systems. Its installation and setup procedure is described below. Perform installation either as root user or as a user with sudo privileges.

 

Uninstall RaptorXML+XBRL Server

If you need to uninstall a previous version of RaptorXML+XBRL Server, do this as follows. On the Linux command line interface (CLI), you can check which Altova server products are installed with the following command:

[Debian, Ubuntu]:   dpkg --list | grep Altova

[CentOS, RedHat]:   rpm -qa | grep server

 

If RaptorXML+XBRL Server is not installed, go ahead with the installation as documented below in Install RaptorXML+XBRL Server.

 

If you need to uninstall an old version of RaptorXML+XBRL Server, do this with the following command:

[Debian, Ubuntu]:   sudo dpkg --remove raptorxmlxbrlserver

[CentOS, RedHat]:   sudo rpm -e raptorxmlxbrlserver

 

On Debian and Ubuntu systems, it might happen that RaptorXML+XBRL Server still appears in the list of installed products after it has been uninstalled. In this case, run the purge command to clear RaptorXML+XBRL Server from the list. You can also use the purge command instead of the remove command listed above.

[Debian, Ubuntu]:   sudo dpkg --purge raptorxmlxbrlserver

 

Download the RaptorXML+XBRL Server Linux package

RaptorXML+XBRL Server installation packages for the following Linux systems are available at the Altova website.

 

Distribution

Package extension

Debian

.deb

Ubuntu

.deb

CentOS

.rpm

RedHat

.rpm

 

After downloading the Linux package, copy it to any directory on the Linux system. Since you will need an Altova LicenseServer in order to run RaptorXML+XBRL Server, you may want to download LicenseServer from the Altova website at the same time as you download RaptorXML+XBRL Server, rather than download it at a later time.

 

Install RaptorXML+XBRL Server

In a terminal window, switch to the directory where you have copied the Linux package. For example, if you copied it to a user directory called MyAltova (that is located, say, in the /home/User directory), then switch to this directory as follows:

cd /home/User/MyAltova

 

Install RaptorXML+XBRL Server with the following command:

[Debian]:   sudo dpkg --install raptorxmlxbrl-2024-debian.deb

[Ubuntu]:   sudo dpkg --install raptorxmlxbrl-2024-ubuntu.deb

[CentOS]:   sudo rpm -ivh raptorxmlxbrl-2024-1.x86_64.rpm

[RedHat]:   sudo rpm -ivh raptorxmlxbrl-2024-1.x86_64.rpm

 

Note:You may need to adjust the name of the package above to match the current release or service pack version.

 

The RaptorXML+XBRL Server package will be installed in the folder:

/opt/Altova/RaptorXMLXBRLServer2024

 

© 2017-2023 Altova GmbH