Enabling Git Source Control with GIT SCC Plug-in

www.altova.com このトピックを印刷 前のページ 1つ上のレベル 次のページ

ホーム >  ユーザーガイドとレファレンス > Source Control > Source Control with Git >

Enabling Git Source Control with GIT SCC Plug-in

To enable Git source control with Authentic Desktop, the third-party PushOK GIT SCC plug-in must be installed, registered, and selected as source control provider, as follows:


1.Download the plug-in installation file from the publisher's website (http://www.pushok.com), run it, and follow the installation steps.
2.On the Project menu of Authentic Desktop, click Change Source Control, and make sure PushOk GITSCC is selected as source control provider. If you do not see Push Ok GITSCC in the list of providers, it is likely that the installation of the plug-in was not successful. In this case, check the publisher's documentation for a solution.


3.When a dialog box prompts you to register the plug-in, click Registration and follow the wizard steps to complete the registration process.

(C) 2019 Altova GmbH