•CentOS 6 or newer
•RedHat 6 or newer
•Debian 8 or newer
•Ubuntu 16.04 LTS or newer
The following libraries are required as a prerequisite to install and run the application. If the packages below are not already available on your Linux machine, run the command yum (or apt-get if applicable) to install them.
•Perform installation either as root user or as a user with sudo privileges.
•The previous version of MapForce Server must be uninstalled before a new one is installed.
•If you are installing FlowForce Server with other Altova server products, it is recommended to install FlowForce Server first.
1.Download the installation package from https://www.altova.com/download#server to a local directory.
2.Change to the directory where you downloaded the installation package, for example:
3.Install the MapForce Server package.
[Debian, Ubuntu] sudo dpkg --install mapforceserver-2020-debian.deb
[CentOS, RedHat] sudo rpm -ivh mapforceserver-2020-1.x86_64.rpm
|Note:||You may need to adjust the name of the package above to match the current release or service pack version.|
1.Ensure that the latest version of Altova LicenseServer (https://www.altova.com/licenseserver) is installed and running either on the local machine or network.
2.Register MapForce Server with Altova LicenseServer. For this, you need to know either the host name or the IP address of the computer where LicenseServer runs. For example, if LicenseServer runs on 127.0.0.1, you can register it as follows:
sudo ./mapforceserver licenseserver 127.0.0.1
|Note:||The command above assumes you are calling the executable from the program installation directory, see also Important Paths.|
3.Log on to LicenseServer administration interface and assign the license to the machine where MapForce Server runs.
For more information about licensing, refer to Altova LicenseServer documentation (https://www.altova.com/documentation).