Network Configuration

www.altova.com Print this Topic Previous Page Up One Level Next page

Home >  Installation > Windows >

Network Configuration

During the installation of FlowForce Server on a Windows operating system, it is possible to configure the following settings:

 

Whether unencrypted connections to FlowForce Server are allowed, and, if yes, on which port.

ff_service_config02

Whether secure (SSL-encrypted) connections to FlowForce Server are allowed, and, if yes, on which port. By default, secure connections are disabled. Note that, in order to enable SSL-encrypted connections, the paths to a certificate and a private key file must also be specified. The host (bind address) can be specified from the Setup page after installation (see Defining the Network Settings).

ff_service_config03

 

Note:        The settings listed above can also be configured for FlowForce Web Server.

 

To define all of the settings above during installation, click the relevant tab (FlowForce Server or FlowForce Web Server) on the installation dialog box, and then click Change.

ff_service_config01

If you prefer to configure the settings above at a later time, click Next. In this case, FlowForce Server will be installed with the default options as shown under each respective tab of the dialog box. After installation, you can change the settings as described in Defining the Network Settings.


© 2019 Altova GmbH