Register RaptorXML(+XBRL) Server

www.altova.com Print this Topic Previous Page Up One Level Next page

Home >  Licensing > Altova LicenseServer > Register and Unregister Products >

Register RaptorXML(+XBRL) Server

RaptorXML(+XBRL) Server must be registered with Altova LicenseServer before a license can be assigned to it. How to register is described below.

 

Registering RaptorXML(+XBRL) Server (Windows)

You can register RaptorXML(+XBRL) Server via its command line interface (CLI) by using the licenseserver command:

 

RaptorXML Server:

RaptorXML licenseserver Server-Or-IP-Address

RaptorXML+XBRL Server:

RaptorXMLXBRL licenseserver Server-Or-IP-Address

 

 

For example, if LicenseServer is running on http://localhost:8088, then register  RaptorXML(+XBRL) Server with:

 

RaptorXML Server:

RaptorXML licenseserver localhost

RaptorXML+XBRL Server:

RaptorXMLXBRL licenseserver localhost

 

 

After successfully registering RaptorXML(+XBRL) Server, you can go to LicenseServer and assign a license to RaptorXML(+XBRL) Server.

 

Registering RaptorXML(+XBRL) Server (Linux)

On Linux machines, RaptorXML(+XBRL) Server can be registered with LicenseServer by using the licenseserver command of the RaptorXML(+XBRL) Server CLI. Note that RaptorXML(+XBRL) Server must be started with root rights.

 

sudo /opt/Altova/RaptorXMLServer2019/bin/raptorxmlserver licenseserver localhost
sudo /opt/Altova/RaptorXMLXBRLServer2019/bin/raptorxmlxbrlserver licenseserver localhost

 

 

In the command above, localhost is the name of the server on which LicenseServer is installed. You can use the server's IP address instead. Notice also that the location of the RaptorXML(+XBRL) Server executable is:

 

/opt/Altova/RaptorXMLServer2019/bin
/opt/Altova/RaptorXMLXBRLServer2019/bin

 

After successfully registering RaptorXML(+XBRL) Server, you can go to LicenseServer and assign a license to RaptorXML(+XBRL) Server.

 

Registering RaptorXML(+XBRL) Server (macOS)

On Linux machines, RaptorXML(+XBRL) Server can be registered with LicenseServer by using the licenseserver command of the RaptorXML(+XBRL) Server CLI. Note that RaptorXML(+XBRL) Server must be started with root rights.

 

sudo /usr/local/Altova/RaptorXMLServer2019/raptorxmlserver licenseserver localhost
sudo /usr/local/Altova/RaptorXMLXBRLServer2019/raptorxmlxbrlserver licenseserver localhost

 

 

In the command above, localhost is the name of the server on which LicenseServer is installed. You can use the server's IP address instead.

 

After successfully registering RaptorXML(+XBRL) Server, you can go to LicenseServer and assign a license to RaptorXML(+XBRL) Server.

 


© 2019 Altova GmbH