During the installation of FlowForce Server on a Windows operating system, it is possible to configure the following settings:
|•||How should FlowForce Server start up as a Windows service: automatic, on demand, delayed automatic, or disabled.|
|•||The operating system user account to be used by FlowForce Server as a Windows service: Local System, Local Service, Network Service, or Other User.|
|•||If FlowForce Server is configured to run as Other User, you can set the username and password of this user, similar to how this is done in the Windows Services management console.|
|Note:||The settings listed above can also be configured for FlowForce Web Server.|
The settings have the same meaning as when you change the service properties from the Windows Services management console.
To define the settings above during installation, click the relevant tab (FlowForce Server or FlowForce Web Server) on the installation dialog box, and, next to Service configuration, click Change.
If you need to change these settings after installation, open the Windows Services management console, and then change the properties of the required service from there. To open the Windows Services management console, open a command line window and type Services.msc.
© 2019 Altova GmbH